Digital Monitoring Products Canadain XR500 Manual de instrucciones descargar pdf (Pagina 69)

XR500 Series Programming Guide Digital Monitoring Products

StoP

Stop

20.1

STOP

Stop

Save Programming

WHEN ANY PANEL PROGRAMMING IS CHANGED, THE STOP ROUTINE MUST BE RUN

AND ‘SAVING PROGRAM’ MUST DISPLAY ON THE KEYPAD IN ORDER TO SAVE THE

PROGRAMMING CHANGES.

At the STOP option, pressing any Select key allows you to exit the Programmer function

of the panel. When selected, the panel performs an internal reset and exits the

programmer.

The STOP routine causes the following conditions to occur:

• All 1100 Series DMP Wireless transmitters are reset to NORMAL

• The panel Status List is cleared

During the reset, all keypad displays are momentarily blank for two seconds. After the

reset, the programming function terminates and the keypads return to the status list

display.

The STOP option does not disarm the system. Any new areas or zones that were added

during programming are not armed until the system is disarmed and armed again.

Missing LX-Bus™ Modules Displayed

The Programmer includes a feature following the STOP routine that displays the name of

any programmed LX-Bus module not currently connected to the panel. For example, if

you had enabled any LX-Bus options and not yet installed a 481 LX-Bus Expansion Card,

after the STOP routine the panel displays NO LXBUS CARD. This is a helpful reminder to

install the card. This feature can also be a troubleshooting tool to indicate a problem

if you installed the card and this message still displays. The following list shows the

different messages and their associated LX-Bus cards.

Keypad Display Missing Card

NO LXBUS CARD 481 LX-Bus™ Expansion Card

NO PRINTER CARD 462P Printer Interface Card

NO HOST CARD 462N Network Interface Card

(with NETWORK communication selected)

The above messages clear automatically from the keypad after a few moments.

Power Up

When the XR500 Series panel is powered up after an AC power failure, any zone

transitions are not recognized for 60 seconds. Normal zone processing resumes at the end

of the 60 seconds.

Set Lockout Code

21.1

SET LOCKOUT CODE

Set Lockout Code

Pressing COMMAND at the STOP option displays SET LOCKOUT CODE. This allows you to

program a code that is then required to gain access to the panel internal Programmer

through the keypad. You can change this code at any time to any combination of numbers

from three to ve digits long. You do not need to enter leading zeros when using the

lockout code. Initializing the panel does not clear a Lockout Code. Lockout Codes can be

changed through Remote Link.

Once you have changed the code, it is important to write it down somewhere and store it

in a safe place. Lost Lockout Codes require the panel to be sent back to DMP for repair.

You may cancel a Lockout Code by entering 00000 at the Set Lockout Code command.

Lockout Code restriction

Do not set a Lockout Code higher than 65535.

Set Lockout code

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 83 84

Comentarios a estos manuales

Sin comentarios

Digital Monitoring Products Canadain XR500 Manual de instrucciones Pagina 69

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Digital Monitoring Products Canadain XR500