Digital Monitoring Products Canadain XR500 Manual de instrucciones descargar pdf (Pagina 23)

XR500 Series Programming Guide Digital Monitoring Products

Messaging setup

Messaging Setup

5.1

MESSAGING SETUP

Messaging Setup

This section allows you to enter the information needed to receive messages

directly from the panel via email and MyAccess™ SMS Text using Network or Cellular

communication. All of the name and password options below allow up to 32 lowercase

characters to be entered. The Destination addresses allow up to 48 characters to be

entered. System Name is displayed with initial caps.

The transmitted messages are:

• Zone Alarms by Zone Name

• Zone Troubles by Zone Name

• Zone Bypass by User

• Arming (Closings) by User

• Disarming (Openings) by User

• Late to Close

• AC Power Trouble and Restoral

• System Low Battery

• Ambush

• Abort, Cancel and Alarm Veried by User

5.2 Enable Messaging

Select YES to allow the panel to send messages to three programmed destinations.

Default is NO.

5.3

SYSTEM NAME

System Name

Enter a unique name for the panel. The panel name is used as the sender of the message.

The text entered is displayed with initial caps. If this eld is left blank, the panel account

number is sent.

5.4

DESTINATION 1

Destination 1

Enter the rst email address or cell phone number where messages will be sent. The

message can be sent to any device (computer, cell phone, PDA) as long as a valid email

address or cell phone number is entered. When entering email addresses, press the

7 digit key followed by the fourth Select Key to add the @ symbol and the 9 digit key

followed by the fourth Select Key to add the _ symbol. See the Entering Non-Alpha

Characters section for additional symbols.

Note: Mail servers that require Transport Layer Security (TLS) encryption are not

supported by the XR500 Series.

5.5 Destination 1 User Number

If Destination 1 is a 10-digit cellular number, enter a user’s user number from this account.

This option is used when sending commands such as arming or disarming back to the panel

using

MyAccess™ SMS Text

from the same cell phone or PDA. The user number must have

the authority to perform the commands as if it occurred at the keypad.

MyAccess™ SMS

Text

command operation is available in XR500 Series panels using version 205 or higher.

Entering 0 (zero) disables this option. Default is 0.

5.6

DESTINATION 2

Destination 2

Enter the second destination email address or cell phone number.

5.7 Destination 2 User Number

If Destination 2 is a cellular number, enter the user’s User Number for

arming/disarming authorization.

5.8

DESTINATION 3

Destination 3

Enter the third destination email address or cell phone number.

5.9 Destination 3 User Number

If Destination 3 is a cellular number, enter the user’s User Number for

arming/disarming authorization.

ENABLE MESSAGING

NO YES

DESTINATION 1

USER NUMBER:

DESTINATION 2

USER NUMBER:

DESTINATION 3

USER NUMBER:

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 83 84

Comentarios a estos manuales

Sin comentarios

Digital Monitoring Products Canadain XR500 Manual de instrucciones Pagina 23

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Digital Monitoring Products Canadain XR500