Digital Monitoring Products Canadain XR500 Guía de usuario descargar pdf (Pagina 24)

System Link User’s Guide

Receiver Tab

The programming options in the System

Link Configuration window are available

on the following tabs, Receiver, Modem,

Database, Other, TCP Trap, Modules,

and Custom Fields.

COM Port

: Set the COM Port option to the

COM port that you want to connect to the

receiver.

Be careful to select a setting that does not

interfere with your mouse, modem, or any

other device on your computer. The COM

port cannot be used for any other purpose

while System Link is running.

Baud rate

: Set the baud rate to the same

setting as your receiver. The default setting is 9600. If you are using an SCS-1 Receiver

Version 812 to access your alarm panels, you may set your baud rate to 19200. The baud

rate set here must also be set in the SCS-1 or SCS-1R Receiver. For more information about

configuring your SCS-1 Receiver, see LT-0065 or SCS-1R Receiver, see LT-0717. If you are

using an SCS-105 Receiver to access your alarm panels, set your baud rate to 9600.

Dial Out Line #

: This number (from 1 - 5) refers to which line card an SCS-1 or SCS-1R

Receiver should use to dial out. If you are using an SCS-105, set this value to 1.

General Options

Areas

: Select which reporting format System Link should use to communicate with panels.

•

Bin

: 2-character hexadecimal mode. Use this mode with SCS-105 Receivers

•

Dec: 2

-character decimal mode. Select this mode if the SCS-1 or SCS-1R Receiver

has been programmed to require Dec mode.

Start Character

: When the SCS-1 or SCS-1R Receiver has a line configured to attach to a

data network, set the Start Character to the same as the character programmed in the

SCS-1 LSU Host Configuration. The default setting is STX. Refer to your SCS-1 Receiver

Guide (LT-0065) or SCS-1R Receiver Guide LT-0717.

•

None:

Use this option when the SCS-1 or SCS-1R Receiver is not connected to a

data network.

•

STX:

Use this option when the SCS-1 or SCS-1R Receiver is configured to use STX.

•

Other:

If the SCS-1 or SCS-1R Receiver is set to a different Start Character than the

available options, select Other and enter that Start Character in the field

immediately to the right of the Start Character menu.

CRC

: Check this box if the SCS-1 or SCS-1R Receiver CRC option is set to yes.

Sequence Numbers

: Check this box if the Sequence Numbers option in the SCS-1 or

SCS-1R Receiver is set to yes.

Lengths

Line#

: This field designates how many characters the receiver uses for the length of the

line number.

•

SCS-1 OR SCS-1R Receivers

: Select 1 to allow single-digit numbers or 2 to allow

two-digit line numbers.

•

SCS-105 Receivers

: Always select 0 for SCS-105 Single Line Receivers.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 103 104

Comentarios a estos manuales

Sin comentarios

Digital Monitoring Products Canadain XR500 Guía de usuario Pagina 24

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Digital Monitoring Products Canadain XR500