Digital Monitoring Products Canadain XR500 Guía de usuario descargar pdf (Pagina 19)

System Link User’s Guide 9

Connecting to a Panel through a Data Network:

• Using an XR500N/XR500E/XR2500F panel

• Using an XR100N panel

• Using an XR200/XR200-485/XR2400F/XR500 panel and

an iCOM or iCOM-E

• Using an XRSuper6/XR20/XR40 panel and an iCOM

• Using an XT30/XT50 panel

To configure System Link to connect to a panel through a data network such as the

Internet, follow the steps below:

1. Select the desired panel in File > Panel Information.

2. In the Connection Information group box, select Network from the drop-down

menu in the Type field.

3. Enter the IP address of the network device connected to the panel. Do not enter

leading zeros when entering the IP address.

Note: You only need to complete these steps one time. On further connections simply

select the panel and then Connect as explained below.

Connecting to a Panel using a 462FM 9600 Baud Modem

To configure System Link and the local computer modem to connect to a panel that has a

462FM 9600 Baud Modem Card installed, follow the steps below:

1. Open System > Configure > System Link and click the Modem Tab.

2. Select the communications port that is connected to your computer modem in the

COM Port field.

3. In the Baud Rate field, enter the baud rate of your computer.

4. Check the Tone Dial box if you wish to tone dial.

5. Enter the length of time System Link waits for the 462FM to pick up in the Dial

Timeout field.

6. If an initialization string is required for the modem communicating to the panel,

enter the setup string in the Initialization String field.

7. Select the desired panel in File > Panel Information.

8. In the Connection Information group box, select Modem from the drop-down

menu in the Type field.

9. Enter the panel phone number in the Phone field.

10. Click the Cfg (Configure) button beside the Phone field to open a dialog box that

allows you to configure the 462FM 9600 Baud Modem.

11. Enter the number of times the site phone rings before the 462FM picks up in the

Ring Count field.

12. Click the Set Modem button to program the 462FM to pick up after the number of

rings entered in the Ring Count field.

Note: You only need to complete these steps one time. On further connections simply

select the panel and then Connect as explained below.

After you have entered all the Connection Information, open the panel by clicking OK.

Then go to Panel > Connect and click the Connect button. You are now connected to

the panel.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 103 104

Comentarios a estos manuales

Sin comentarios

Digital Monitoring Products Canadain XR500 Guía de usuario Pagina 19

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Digital Monitoring Products Canadain XR500