Digital Monitoring Products 1912XR Guía de instalación descargar pdf (Pagina 8)

Digital Monitoring Products, Inc.

1912XR Programming

Page 2

1-INTRODUCTION

1.2 Getting Started continued

Accessing the Programmer

To access the Programmer function of the 1912XR:

1. Install the reset jumper across the two J16 reset pins for two seconds. See Figure 1.

2. Remove the reset jumper and place it over just one pin for future use.

3. Enter the code 6653 (PROG) into any Security Command keypad.

4. Press COMMAND.

5. The keypad displays: PROGRAMMER.

You are now ready to start programming the 1912XR panel. Pressing the COMMAND key scrolls

you through the programming functions listed in section 1.3. Each of these functions are described

in detail in sections 2 to 15 of this manual.

1.3 Programmer Operation

Once at the PROGRAMMER display, pressing the COMMAND key scrolls you through the

programming menu. There are 14 programming sections to choose from:

Menu Item Section in this manual

Initialization 2

Communication 3

Device Setup 4

Remote Options 5

System Reports 6

System Options 7

Output Options 8

Menu Display 9

Status List 10

Printer Reports 11

Area Information 12

Loop Information 13

Stop 14

Set Access Code 15

AC BELL

34 56 789

14 15

17 18 19

GND

RED YEL GRN BLKB + B - SMK L5+ L5- L1 L2 L3 L4GNDGND

1k Ω

3.3k Ω Resistor

DMP Model 309

1k Ω

Battery Only Restart

J16

Command Processor Reset

1k Ω

Cold Water Pipe

Earth Ground

Figure 1: Installing the reset jumper on J16

J16

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 41 42

Comentarios a estos manuales

Sin comentarios

Digital Monitoring Products 1912XR Guía de instalación Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Digital Monitoring Products 1912XR