Digital Monitoring Products 1912XR Guía de instalación descargar pdf (Pagina 19)

Digital Monitoring Products, Inc.

1912XR Programming

Page 13

5.7 SERVICE RECEIVER AUTHORIZATION - YES enables remote commands and

programming to be accepted from a secondary service receiver other than the

alarm SCS-1 Receiver. The Remote Key option can also be required.

With YES selected, the panel requests the service receiver key the first time it's

contacted by the service receiver. The panel retains this service receiver key in

memory and accepts remote commands from the service receiver.

If an alarm occurs during a remote connect, the panel disconnects from the

service receiver and calls the alarm receiver. Alarm reports are only sent to the

alarm receiver. It is important that the alarm receiver key and the service

receiver key programmed at the central station are NOT the same so the panel

can determine the difference between receivers.

When NO is selected remote commands and programming are not accepted

from a secondary service receiver.

5.8 REMOTE PHONE NUMBER - Press COMMAND to enter the phone number the

panel dials whenever remote programming is requested. After entering a phone

number, the panel allows remote commands and programming only after it has

first been called by the authorized receiver, disconnected itself, and has redialed

the remote phone number.

Note: If a Remote Phone Number is entered, and the function 984 + COMMAND

is entered at the keypad, a remote options menu appears. This menu contains

the following options:

NUMBER - The panel allows you to enter into the keypad a phone number you

want the panel to dial. Use must use any required prefixes and area codes.

REMOTE - The panel dials the phone number programmed in Remote Phone

Number. See section 5.8.

PICKUP - The panel picks up the phone line as Remote Access is dialing in. The

phone must be ringing before selecting PICKUP.

If a Remote Phone Number is NOT entered, the panel allows remote commands

and programming without disconnecting and redialing. The phone number can be

up to 15 digits in length. Enter a D for dial tone detect and a P for a 3 second

pause.

Important: Do not program any letters other than P or D.

5.9 REMOTE DISARM - Enter YES to enable the panel to be disarmed remotely.

Selecting NO disables remote disarming.

REMOTE PHONE NO.

SVC RCVR YES

–

DISARM NO

NBR RMT PICKUP

5-REMOTE OPTIONS

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 41 42

Comentarios a estos manuales

Sin comentarios

Digital Monitoring Products 1912XR Guía de instalación Pagina 19

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Digital Monitoring Products 1912XR